ShapeShift Adjustable RetentionUpdated 6 months ago

ShapeShift Series Holsters will have our proprietary adjustable retention unit.  From virtually no retention to impossibly tight, this retention unit can be adjusted anywhere in-between. 

Using a Twist Lock from your holster or the extra one in the parts pack, insert the squared off side of the Twist Lock into the square hole.  Twisting clock-wise will increase the retention.  It is recommended to use half turns initially and then test after each adjustment to find your ideal retention. 

If the Adjustable Retention Unit feels stuck or does not turn reasonably freely, it may be possible the gears underneath are not synced and interfacing as interfacing as designed.  This can usually be rectified with a little extra leverage.  A 1/4 inch bit driver is ideal, but a flat head screwdriver big enough to seat diagonally will work in a pinch. A screwdriver may mar the polymer but should not impact performance of the retention device.  If the extra leverage does not realign the gears by turning clockwise, apply pressure on the alien head and try again by twisting the driver back and forth.  This should ensure both gears within the retention unit align.